Install the product on a network
In this configuration, the product is connected directly to the network and can be configured to allow all
computers on the network to print directly to the product.
Table 5-3
Messaging and management (continued)
38
Chapter 5 Connectivity
ENWW
NOTE:
This mode is the recommended network configuration for the product.
1.
Before turning on the product, connect the product directly to the network by inserting a network
cable into the product network port.
2.
Turn on the product, wait 2 minutes, and then use the control panel to print a configuration page.
NOTE:
Make sure that an IP address is listed on the configuration page before proceeding to the
next step. If an IP address is not present, reprint the configuration page.
3.
Insert the product CD into the computer. If the software installer does not start, navigate to the
setup.exe file on the CD and double-click the file.
4.
Follow the installer instructions.
NOTE:
When the installer prompts for a network address, provide the IP address listed on the
configuration page that you printed before starting the installer program, or search for the product
on the network.
5.
Allow the installation process to complete.