HP LaserJet P2055 Printer series - Install product memory

background image

Install product memory

This product has one DIMM slot.

CAUTION:

Static electricity can damage DIMMs. When handling DIMMs, either wear an antistatic

wrist strap or frequently touch the surface of the DIMM antistatic package, then touch bare metal on the
product.

If you have not already done so, print a configuration page to find out how much memory is installed in
the product before adding more memory. See

Print the information pages on page 70

.

1.

After the configuration page has printed, turn the product off and disconnect the power cord.

2.

Disconnect all interface cables.

ENWW

Install memory

85

background image

3.

Open the DIMM-access door on the left side of the product.

4.

Remove the DIMM from the antistatic package.

CAUTION:

To reduce the possibility of damage caused by static electricity, always wear an

electrostatic discharge (ESD) wrist strap or touch the surface of the antistatic package before
handling DIMMs.

5.

Hold the DIMM by the edges, and align the notches on the DIMM with the DIMM slot. (Check that
the locks on each side of the DIMM slot are open.)

86

Chapter 9 Manage and maintain the product

ENWW

background image

6.

Hold the DIMM at a 45-degree angle, and then push the upper contacts of the DIMM firmly into the
slot. Make sure that the locks on each side of the DIMM snap into place.

CAUTION:

Pressing the DIMM straight down will damage the contact pins.

NOTE:

To remove a DIMM, first release the locks.

ENWW

Install memory

87

background image

7.

Close the access door, and press firmly until it snaps into place.

8.

Reconnect the interface cables and the power cord.

9.

Turn the product on.